MITSUBISHI Parts
elevator Door Machine Board Mitsubishi DOR-545A DOR-545B DOR-546A DOR-546B elevator parts
I.Mitsubishi DOR-545A board installation and use guide:
1.Software preparation :
Programming software : Open and install Mitsubishi programming software in sequence, and pay attention to registering with registration code 570-986818410 .
Simulation software : Install Mitsubishi simulation software, serial number is 961-500947269 .
Touch screen editing : Install and open Mitsubishi touch screen editing and simulation software .
2.Installation steps :
Hardware connection : Make sure that the Mitsubishi DOR-545A board is correctly connected to other devices, such as PLC, etc.
Software configuration : Configure relevant parameters in the programming software to adapt to specific application scenarios.
Testing and debugging : After completing the installation, test to ensure that the board works properly and debug as needed..
II.Common faults and solutions of Mitsubishi DOR-545A board:
1.UVT fault (undervoltage fault) :
Cause: Damage to the optocoupler is a common cause, resulting in abnormal voltage signal sampling.
Solution: Check and replace the damaged optocoupler components.
2.E6, E7 faults :
Cause: Integrated circuit 1302H02 is damaged. The signal isolation optocoupler is damaged. The connector is damaged or has poor contact.
Solution: Check and replace the damaged integrated circuit or optocoupler. Check and repair the connector to ensure a good connection.
Send your enquiry with our high quality elevator Door Machine Board Mitsubishi DOR-545A DOR-545B DOR-546A DOR-546B elevator parts.
description2