elevator display board OTIS FAA23600AA1 Arrival bell with horn
DESCRIPTION
|
NO |
Type |
Weight |
Application |
Material |
|
1 |
Display board |
1KG |
Elevator parts |
Copper Foil |
Regarding the replacement of the Otis FAA23600AA1 display board, since the specific steps may vary depending on different models and installation environments, the following are general guidelines:
1. Power off and safety measures:
First, make sure the elevator is completely powered off and follow relevant safety operating procedures, such as wearing protective equipment.
2. Remove the old display board:
According to the elevator maintenance manual or professional guidance, find the fixing screws or clips of the display board and carefully remove it. Remember to record the layout of the connection wires for subsequent installation.
3. Install the new display board:
Install the new FAA23600AA1 display board into the elevator control cabinet in reverse order. Make sure all connection wires are correctly connected and tighten all screws or clips.
4. Test and verification:
Reconnect the power and test according to the elevator commissioning procedure to ensure that the new display board is working properly and the functions of the elevator are not affected.
Please note that the above steps are for reference only. The specific operation should be based on the official maintenance manual of Otis Elevator or contact professional elevator maintenance personnel for guidance.